Skip to main content

Re: Tabaluga's

Sounds good @Oaktree  - doing some special things helps make the rest seem ok 🙂

TAB
Senior Contributor

Re: Tabaluga's

fair enough @Bill16  should have gone into Rocko, streets paved w money, coulda got a shift for $70/hr

TAB
Senior Contributor

Re: Tabaluga's

nice one @Oaktree 😊

Re: Tabaluga's

Have you got a plasma cutter man @TAB 

TAB
Senior Contributor

Re: Tabaluga's

nah, not got anything really @Bill16  they can be pretty handy. cut 25mm thick wear plates with one if its big enough

Re: Tabaluga's

Yeah righto @TAB the gas axe can cut through a fair bit can't it?

TAB
Senior Contributor

Re: Tabaluga's

.. I've done 3 inch plate on profile cutter @Bill16  2 inch thick by hand re oxy

the lance is pretty wild, done 18mm rods 3 plus metres long goes through anything, like a chrome tube packed w magnesium wires that run length of the tube, some small ones only 2 ft long  you put the tube in the holder , get some one to heat up the end w oxy , then turn tap on hand on real slow til it catches then could chop an army tank in half or anything lol

https://youtu.be/94VTyPSfgtI?si=kPTeSZc6l5rKa04U

https://youtu.be/IY-XTKRzwQo?si=jbpYiInE57fYwFhh

 

Read more in depth: https://www.materialwelding.com/how-the-burning-bars-and-oxygen-lance-cutting-works/

Re: Tabaluga's

@Bill16 hey cool friend, very nice to see you. Glad you went to the beach. Hope you're going well. Going okay here. Have a nice evening. Take care

 

Re: Tabaluga's

@Oaktree very good👍👍👍

Re: Tabaluga's

@TAB hey tabby, very interesting re cutting Lance. Just cooking dinner here.